Colt 1911 Grips ? Black Rosewood with Dragon Scales and Ruger Medallion, Full Size

These Colt 1911 grips are cut from black rosewood, carved across the face with an overlapping dragon scale pattern, and finished with a matte black Ruger medallion inlaid flush into each panel. Built for Colt Government and Colt Commander owners who want carved-wood character on their pistol, and a clean option for Ruger SR1911 shooters who like the look and want matching branding. The dragon scale relief catches light from every angle in a way that checkered or smooth panels can’t match. Engineered as a true bolt-on upgrade. Pull your factory panels, set these in place, tighten your existing grip screws. No sanding, no shimming, no gunsmith. Sized for full-size single-stack 1911s with the standard 3-1/16″ screw spacing, Colt Government, Colt Commander, Ruger SR1911, and Government-spec clones from Kimber, Springfield, S&W SW1911, Remington R1, Sig 1911, Rock Island, GSG, and Taurus. Cut for ambidextrous safeties. Will not seat on Officer/compact frames, 2011 double-stacks, or magwell-cut competition builds. If you’ve been weighing custom 1911 grips against the factory panels that came with your Colt, this is where the gap shows up. Black rosewood is one of the hardest, most stable woods used in 1911 grip panels, denser than standard rosewood, less prone to warping than walnut. The dark grain holds the dragon scale carving cleanly and gives the matte medallion a backdrop that doesn’t compete with the logo. Every medallion is inlaid into the wood, not surface-glued, so it stays flush through years of solvents, oils, and range trips. Cut, carved, and finished in North Carolina. Over 50,000 1911 grips shipped to American shooters. 30-day returns if the fit isn’t right or panels arrive damaged.